Use the following guidelines when installing hard drives: You should only use drives that have been tested and approved by the system manufacturer. You may need to use different programs than those provided with the operating system to partition and format a hard drive. When you format a high-capacity hard drive, allow enough time for the formatting to be completed. Long format times for these drives are normal.

Author:Malakora Kajizilkree
Country:New Zealand
Language:English (Spanish)
Published (Last):14 November 2015
PDF File Size:14.65 Mb
ePub File Size:17.51 Mb
Price:Free* [*Free Regsitration Required]

Model naming[ edit ] Over the years, many different types of PowerEdge servers have been introduced and there was wide variety of product and family codes used within the PowerEdge name.

Itanium servers[ edit ] The Dell Itanium-based servers were introduced before this new naming-convention was introduced and were only available as rack servers. New naming conventions[ edit ] Three digits Since the introduction of the Generation 10 servers in Dell has adopted a standardized method for naming their servers; the name of each server is now represented by a letter followed by 3 digits.

The first digit refers to the number of sockets in the system: 1 to 3 for one socket, 4 to 7 for two sockets, and 8 or 9 for four sockets. The middle digit refers to the generation: 0 for Generation 10, 1 for Generation 11, and so on. Whereas the R is a two-socket, 10th generation AMD-based rack-server. The second digit indicates the generation, with 0 for 10th generation, 1 for 11th generation and so on.

The third digit indicates the number of CPU sockets, 1 for one socket and 2 for two sockets. Blade servers[ edit ] Since Generation 10 there are models for the Me enclosure. The blade-servers in Generation 8 and Generation 9 are using another enclosure that is not compatible with the current Me system.

In form-factor there are two models: half-height and full-height. In an enclosure you can fit 8 full or 16 half-height blades or a mix.


Dell 600SC - RAID 1 & Intel Gigabit NIC Problems

Spare Parts and Upgrades 1. What type of memory will my PowerEdge SC support? To determine the FSB speed configuration, enter System Setup during the boot-up process by pressing the F2 function key as prompted. Look for the CPU Information section. More information on viewing this information in System Setup can be found here. What memory features does the PowerEdge SC support? ECC Error Checking and Correcting ECC support means that the system can detect and correct any single-bit memory errors that may occur without interruption of service.

IN4007 M7 PDF

Dell PowerEdge 600SC Installation Manual



List of Dell PowerEdge Servers


Related Articles